Which Roland TD316 and TD313 models work with WebEDrums?
The table lists what Roland's TD316 and TD313 pages say, checked on 11 November 2026. Roland marks the TD-17KV2 and TD-17KVX2, on the Roland TD-02 page, as discontinued; its pages do not say that the 3 Series replaces them, so this page does not either. The V-Drums 5 Series page covers the kits above these. We have not played or connected a V31 kit.
| Model | What the manufacturer lists | In WebEDrums |
|---|---|---|
| Roland TD316 | Roland lists a V31 module, a PD-12P snare with three sensors and positional sensing, two PD-8H toms and a PD-10H tom, a VH-10 hi-hat that mounts on a hi-hat stand, two CY-12C-T dual-zone crashes (the second on the CRASH 2 jack), a CY-14R-T ride with bow, edge and bell triggering, a KD-10 kick pad and an MDS-Compact 2 stand. The kick pedal, the hi-hat stand, the snare stand and the throne are not included. | The Roland preset's notes, over the USB cable (see the preset section for what we have not checked on the V31). Map the second crash to the Crash 2 row. The AUX/TOM 4 jack is free for another pad, which has no slot of its own in WebEDrums. |
| Roland TD313 | The same V31 module, toms, ride and KD-10 kick pad, with a PDX-12 snare that Roland describes with cross-stick detection, a CY-5 hi-hat with an FD-9 control pedal, one CY-12C-T crash and an MDS-Compact stand. The kick pedal is not included. Both extra trigger jacks, CRASH 2 and AUX/TOM 4, are free. | The same connection and preset. With one crash, leave the Crash 2 row empty in the guided setup; a second crash on the CRASH 2 jack maps there later. |
Questions about the Roland TD316 and TD313 models
What is the difference between the TD316 and the TD313?
Both are built on the V31 module, with the same toms, ride and kick pad. Roland's lists differ in four parts: the snare (a PD-12P with positional sensing on the TD316, a PDX-12 on the TD313), the hi-hat (a VH-10 on a hi-hat stand, against a CY-5 pad with an FD-9 control pedal), the crashes (two against one) and the stand. In WebEDrums the connection and the preset are the same; the TD316's second crash maps to Crash 2.
Does the V31 need a driver to work with WebEDrums?
Not for MIDI. Roland's V31 manual describes two USB driver modes: GENERIC uses the operating system's own driver and carries USB MIDI with two channels of audio, and VENDOR uses Roland's V31 driver and carries USB MIDI with 30 recording and 32 playback channels. WebEDrums needs only the MIDI, which both modes carry. The mode is under MENU, SYSTEM, USB AUDIO, Driver Mode, and Roland says a change takes effect after the module is switched off and on again.
Which USB cable does the V31 need?
The V31's USB COMPUTER port is USB Type-C. Roland's troubleshooting page for the V31 says the module does not work with USB 3.0 cables and tells you to use a USB 2.0 cable, so if the computer does not see the module, the cable is the first thing to change.
Can I add a fourth tom or a digital pad and use it in WebEDrums?
Roland lists two extra trigger jacks on the V31, CRASH 2 and AUX/TOM 4, and a DIGITAL TRIGGER IN port for a digital pad sold separately. WebEDrums has pad slots for three toms and two crashes: a second crash maps to Crash 2, a pad that replaces the snare, ride or hi-hat is recorded in that pad's slot, and a fourth tom has no slot, so its notes are silent rather than counted as stray hits.
How do the Roland TD316 and TD313 connect to a computer?
Through the V31's USB COMPUTER port, which is USB Type-C. Roland's manual describes two driver modes: GENERIC, which uses the operating system's driver and carries USB MIDI and two channels of audio, and VENDOR, which needs Roland's V31 driver and carries USB MIDI and multi-channel audio. WebEDrums needs only MIDI, so GENERIC works with nothing installed, and a module already in VENDOR mode for recording needs no change. The setting is under MENU, SYSTEM, USB AUDIO, Driver Mode, and takes effect after a power cycle.
Roland's troubleshooting page says the V31 does not work with USB 3.0 cables: use a USB 2.0 cable. The specification also lists a MIDI OUT connector and mentions Bluetooth for audio and MIDI; we have tested neither, and the connection described here is the cable.
Which preset do I pick in WebEDrums?
The kit setup page starts from the Roland defaults, the table below, when the module's USB name contains Roland, TD- or V-Drums, and says so: "Using the Roland defaults". We have not connected a V31, so we do not know the name it reports. If the page says "Using the General MIDI defaults" instead, or a pad lights the wrong drum, choose "Record every pad": the app listens to each pad in turn, zone by zone, and saves what it hears, which works for any module.
The same goes for the note numbers. Roland keeps the V31's defaults in the module's Data List, which we have not checked against the table below; the recorded setup does not depend on them. Review each pad's lane before saving, and change it later in Settings, Kit, Edit mapping.
Which pads and zones does the Roland preset map?
This table is generated from the preset inside the app, so it is what WebEDrums listens for when you choose the Roland defaults. Several notes end up on one lane on purpose: the games have one red lane, not a head and a rim.
| Pad | Notes the preset listens for | Plays as |
|---|---|---|
| Kick | 36 head | Kick |
| Snare | 38 head · 40 rim · 37 cross-stick | Red (snare) |
| Hi-hat | 46 bow · 26 edge · 42 bow · 22 edge | Yellow cymbal |
| Tom 1 (high) | 48 head · 50 rim | Yellow tom |
| Tom 2 (mid) | 45 head · 47 rim | Blue tom |
| Floor tom | 43 head · 58 rim | Green tom |
| Crash | 49 bow · 55 edge | Green cymbal |
| Ride | 51 bow · 59 edge · 53 bell | Blue cymbal |
| Crash 2 (optional) | 57 bow · 52 edge | Green cymbal |
- Second crash: the TD316's second CY-12C-T is on the CRASH 2 jack; map it to the Crash 2 row. On the TD313 the row stays empty until you add one.
- Ride: Roland lists bow, edge and bell triggering on the CY-14R-T. All three play the blue cymbal: the games have one ride lane.
- Hi-hat: open and closed notes on the bow and the edge all play the yellow cymbal, from the TD316's VH-10 on its stand as from the TD313's pad and pedal. Pedal position messages are ignored and only the notes count.
- AUX/TOM 4 and the digital trigger port: a pad that takes over the snare, the ride or the hi-hat is recorded in that pad's slot; a fourth tom has no slot and stays silent.
How do I keep the latency down?
Roland lists a MIX IN mini jack on the V31 for a music player and a PHONES jack. A 3.5 mm cable from the computer's headphone output into MIX IN puts the song next to the kit in the module's headphones, with no software delay on the drums; Roland's pages do not describe how MIX IN is balanced, so check the module's guide. The module also streams audio over Bluetooth, which adds its own delay to the song.
The module's own sounds have no software delay, so headphones on the module are the lowest-latency way to hear the kit. If you would rather hear the browser's drum sounds ("Kit sounds in the browser" in Settings, Audio, six kit styles), run the timing calibration once: eight clicks, hit the snare on each, about six seconds. It measures your computer's audio delay and judges hits against what you heard. Audio sent to the module or the headphones over Bluetooth adds its own delay to the song, so calibrate again after switching to it, or stay wired.
What works in Chrome, Edge and Firefox?
Chrome and Edge on Windows, macOS and Linux, and Chrome on ChromeOS. The module appears as a USB MIDI device under its own name after a one-time MIDI permission (Chrome has prompted for all MIDI access since version 124), and the setting survives reloads. Safari has no Web MIDI, so a Mac needs Chrome, Edge or Firefox. If the browser lists nothing, check that the cable carries data, try another port without a hub, and close any other program that has the module open.
Firefox 108 and newer reads the module over the same Web MIDI. Switch the module on and plug it in before you open Firefox, because Firefox lists MIDI devices only when it starts. The first time, it asks to install a small site-permission add-on for WebEDrums: accept it. It also forgets the songs folder between visits. The Firefox section of the connection FAQ has the fixes when it does not ask or does not see the kit.
Which games and apps read the Roland TD316 and TD313?
Any of them that takes MIDI, since the module sends standard notes over USB. The setup differs per program: the Clone Hero drums setup and the YARG drums setup guides walk through the desktop games with the fixes for a kit that is not detected; the connection guide covers cables and drivers for all of them; and the comparison lays the apps side by side, WebEDrums included.
Not bought it yet, or thinking of the next kit?
The buying guide puts the Roland TD316 and TD313 next to the other kits with a setup page here: level, price range, what each maker lists for the pads, the hi-hat, the kick and the room to grow, and what owners complain about on each. The other Roland kits are on the Roland page.
Sources
Checked on November 11, 2026. If one of these pages has changed and this guide has not caught up, tell us on the contact page.
- Roland: TD316 product page (kit parts, V31 module, trigger inputs)
- Roland: TD316 specifications (kit configuration, what is not included)
- Roland: TD313 product page (kit parts)
- Roland: V31 specifications (connectors, USB modes and channels)
- Roland: V31 reference manual, Configuring the USB driver
- Roland: V31 reference manual, Troubleshooting (USB cables, Driver Mode)
- Roland: V-Drums kits (the current line-up)
- Chrome for Developers: Web MIDI permission prompt